Issue |
Mechanics & Industry
Volume 17, Number 7, 2016
STANKIN: Advanced scientific studies and research in Mechanical Engineering
|
|
---|---|---|
Article Number | 709 | |
Number of page(s) | 5 | |
DOI | https://doi.org/10.1051/meca/2016073 | |
Published online | 30 December 2016 |
Fretting wear resistance of aluminum alloy specimens manufactured by laser microcladding
Moscow State University of Technology “STANKIN”, 1 Vadkovsky per., 127994
Moscow GSP-4, Russia
a Corresponding author:
gvozdevago@mail.ru
Received:
18
October
2016
Accepted:
29
November
2016
This paper reports the results of studies of the fretting wear resistance of specimens manufactured by laser microcladding. The initial materials were powders of Al-Si hypereutectic alloy which contained: (70–74)wt.% Al (26–30)wt.% Si. %. The influence of the laser microcladding parameters on hardness and fretting wear resistance of the cladded materials was investigated. It was found that hardness and wear resistance of the cladded material increased with the decrease of powder mass flow.
Key words: Laser microcladding / aluminum alloy / Al-Si system alloy / fretting wear
© AFM, EDP Sciences 2016
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.