Mechanics & Industry

Effect of heat transfer on shear flow around an obstacle

Soumaya Hadj Salah, Mohamed Toumi, Walid Hassen, Habib Ben Aissia and Jacques Jay

Mechanics & Industry, 20 5 (2019) 505

Published online: 16 July 2019

DOI: https://doi.org/10.1051/meca/2019027

Performance comparison of vegetable oil based nanofluids towards machinability improvement in hard turning of HSLA steel using minimum quantity lubrication

Anshuman Das, Saroj Kumar Patel and Sudhansu Ranjan Das

Mechanics & Industry, 20 5 (2019) 506

Published online: 16 July 2019

DOI: https://doi.org/10.1051/meca/2019036

Numerical and experimental investigation on the effect of the two-phase flow pattern on heat transfer of piston cooling gallery

Lijun Deng, Jian Zhang, Guannan Hao and Jing Liu

Mechanics & Industry, 20 5 (2019) 507

Published online: 16 July 2019

DOI: https://doi.org/10.1051/meca/2019032

Energy, exergy, and economic analysis of a new triple-cycle power generation configuration and selection of the optimal working fluid

Mohammadreza Zeinodini and Mehdi Aliehyaei

Mechanics & Industry, 20 5 (2019) 501

Published online: 15 July 2019

DOI: https://doi.org/10.1051/meca/2019021

Influence of rotating magnetic field on Maxwell saturated ferrofluid flow over a heated stretching sheet with heat generation/absorption

Aaqib Majeed, Ahmed Zeeshan, Farzan Majeed Noori and Usman Masud

Mechanics & Industry, 20 5 (2019) 502

Published online: 15 July 2019

DOI: https://doi.org/10.1051/meca/2019022

A modeling study on the effect of operating parameters on RHCM process using split flow channels design

Fatma Kria, Moez Hammami and Mounir Baccar

Mechanics & Industry, 20 5 (2019) 503

Published online: 15 July 2019

DOI: https://doi.org/10.1051/meca/2019024

Energy and exergy comparison of three similar combined power cycles

A.A. Golneshan and H. Nemati

Mechanics & Industry, 20 5 (2019) 504

Published online: 15 July 2019

DOI: https://doi.org/10.1051/meca/2019025

Dynamic characteristics of water-lubricated journal bearings - Part 1: Full 3D transient hydrodynamic force models using structured mesh movement algorithm

Qiang Li, Shuo Zhang, Yujun Wang, Weiwei Xu, Zengli Wang and Zhenbo Wang

Mechanics & Industry, 20 4 (2019) 404

Published online: 11 July 2019

DOI: https://doi.org/10.1051/meca/2019037

Bending improvement in Spot Heating of pipes in comparison with Line Heating method

Seyed Ehsan Chavoshi and Seyed Ebrahim Moussavi Torshizi

Mechanics & Industry, 20 4 (2019) 405

Published online: 11 July 2019

DOI: https://doi.org/10.1051/meca/2019030

Inlet pressure simulation of pigging in uphill gas pipeline

Honggang He, Zheng Liang and Yishan Guo

Mechanics & Industry, 20 4 (2019) 406

Published online: 11 July 2019

DOI: https://doi.org/10.1051/meca/2019020